It is very simple, connect the speaker wires from the head unit accordingly. You can even buy an adapter for the factory radio that will connect to your factory harness and then all the speaker wires are available without the harness being cut off. They come with a wiring diagram that is very easy to follow. After that, everything is the same such as: the fused power wire from the battery, and the RCA's to the amp from the adapter and a remote wire to the amp from your factory radio the wiring diagram with the harness adapter will tell you which one it is.
How to Install a Subwoofer to a Factory Stereo: A Quick Guide
Chevrolet Monte Carlo Car Radio Wiring Diagram - MODIFIEDLIFE
A factory stereo system could have a very disappointing bass. The solution to this is to install a subwoofer to the factory stereo. Before you even install a subwoofer, you might be wondering if you need one and what difference it would make. While there are audio gadgets that can perform well without it, like some good non-subwoofer soundbars , having one certainly has benefits. A subwoofer enhances the audio experience and improves the performance of the speaker at higher frequencies.
How Do You Hook Up An Amp And Sub To My Factory Radio?
Reason I asked it's because my factory radio did not come with remote wire to amp. Usually comes in blue and white stripe wire from aftermarket stereo. So if I hook up the remote wire to one of the speaker wire in the factory radio will it work as accessory power to send power signal to my amp? And turn off when key is off the car?
Last Updated: December 2, References. This article was co-authored by our trained team of editors and researchers who validated it for accuracy and comprehensiveness. There are 18 references cited in this article, which can be found at the bottom of the page. This article has been viewed 1,, times.